View of antenna system, Yagis toward Cabbage Hill
And broadband loops toward Heppner Valley

Cable entrance for TAR antennas, showing meet-point of 1/2" copper line
with Nickel plated Type 'N' connectors, Polyphasers,and
LMR400 jumpers leading to T.A.R. Repeater Stations

Rear view of Repeater Stations, showing the
75 Amp Battery Charger-Equalizer at the top
The Main Repeater rack immediately below
The hot standby controller in the center
With the Standby Repeater at the bottom
Each repeater rack also contains a 25 Amp
Power Supply for additional redundancy

Front View of Station, The timer control in the center is an
additional feature that automatically returns transmission to
the main transmitter once a defect has been corrected
The receiver voting selector to the left of th timer
ALWAYS uses the receiver with the best S/N ratio.
This cabinet also has space available for additional
equipment by removing the panels at the bottom

View of Battery Cabinet from outside

View inside Battery cabinet, these are Valve-Regulated,
Chemical Recombinant cells (Dynasty) designed for use
in large industrial UPS systems where electronics are
contained within the same cabinet. The empty rack space
will allow CSEPP to add not only additional batteries, but
additional communications equipment.